Anyway, the sliding door to the bathroom was getting hard to slide, the roller had worn down and the door was sliding on the roller axle, which fortunately was made of the same material as the roller.
Removed roller, went to hardware store, confused about the size of the roller, bought a 31 mm roller where as I found out a 29 mm roller was what was needed.
The 31 mm roller went in, but the door retaining lug had to be disabled because it wouldn't fit, just simply rotated it so that it wasn't under the slide. Door slid wonderfully.
Wife come in, gives door an almighty shove to open it as normal and wham! it goes sliding to the end, bounces, knocks off the pelmet, it crashes to the ground, breaking the towel rack and a tile, then bounces and breaks the toilet seat.
Back to the hardware store, and this time bought a new toilet seat and a couple of 29 mm rollers.
This is how the roller and its retaining clip (reaching under the slide) should look like.
No comments:
Post a Comment